Is there a way to remove a sound that has been created within AXMA?
Or, if not delete, a way to reset the sound and render it again?
One of my slightly longer sounds of a clock striking midnight and fading out is about 10 seconds long. It starts to play, then starts over, then stops before the end of the sound, cutting off abruptly. It sounds very bad when this happens and ruins the atmosphere.
When I go into the panel where all the sounds are and play the clip, it does the same thing, so it seems AXMA has recorded the sound incorrectly.
Is there a way to fix this, either by deleting the sound clip and loading it again, or another way to do so?
---
Есть ли способ удалить звук, который был создан в AXMA?
Или, если не удалить, способ сбросить звук и снова отобразить его?
Один из моих немного более длинных звуков часов, поражающих полночь и исчезающих, составляет около 10 секунд. Он начинает играть, затем начинается, затем останавливается до конца звука, резко отключая его. Звучит очень плохо, когда это происходит и разрушает атмосферу.
Когда я вхожу в панель, где звучат все звуки и воспроизводит клип, он делает то же самое, поэтому кажется, что AXMA записал звук неправильно.
Есть ли способ исправить это, удалив звуковой клип и загрузив его снова, или другим способом сделать это?
Неактивен
You can delete the added sound via the View / Sprite and Sounds menu.
Неактивен
No, it's just a standard player.
Неактивен